![]() ![]() Also if more than one set of transmitters and receivers are in use, they should have different dip switch settings. Sometimes there may be interference in an area and switching the dip switches can help resolve an issue if everything seems to be working during the testing but starts are still be missed more than once in a great while. Confirm that the dip switches are in the same position. In the front of the receiver is a little black circle, it pops off. The key is to be sure that the position of these switches is mirrored in the receiver. Each switch is numbered and can be toggled on or off. Inside there are four little white dip switches. The one on the right will pop out - really it does, just get a fingernail under it. On the back of the transmitter there are little black circles. They say check the internal dip switches but do not give additional instruction on that. if signal is not being received when completing step one of their guide (unplug banana plug for transmitter wire and push the signal button)Ī. You may need these parts depending on the diagnosis below.Ģ. Wired and wireless start sensors are not interchangeable. an extra WIRELESS (red covering) start sensor. an extra transmitter wire (the black and green bananas on one end to XLR on the other)Ĭ. Every timer using RadioLynx should always have the following on hand:ī. Lynx System Developers has world class tech support for it’s users and they recently published an updated guide to troubleshooting a RadioLynx problem.Īs usual, I have a few additional thoughts:ġ. Occasionally something goes wrong with the system and starts are not being received. RadioLynx is a wireless start system manufactured by MicroGate that interfaces with Lynx System Software and cameras to trigger a Fully Automatic Time for an event such as a track and field race. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |